AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Goodsync differential11/8/2023 Ensure that 'Control Panel -> Hardware and Sound -> Power Options -> Edit power plan -> Change Advanced Power Settings -> Sleep -> Ensure 'Allow Wake Timers' is enabled. NOTE: If your computer goes to Sleep/Standby, GoodSync can wake it up for the On Schedule job. If a field is left empty, it will run for every unit value of its range. These time unit values can be set by clicking the "Configure" button: This option allows GoodSync to Analyze and Sync this job on a specified schedule. NOTE: Does not work in Unattended mode, as the GoodSync Runner service always runs. Normally, Windows sees that GoodSync is performing file operations and allows completion, but results may vary. Note that Windows may try to close GoodSync on Logoff. This option allows GoodSync to Analyze and Sync this job just before Logoff from Windows. The fields to the right allow you to specify the hours and minutes between Analyzing and Syncing. This option allows GoodSync to Analyze and Sync this job periodically. NOTE: This setting does not work in Unattended mode, as the GoodSync Runner service always runs. The On GoodSync Start Delay timer determines how many seconds after GoodSync starts to begin the Job. This setting should not be used together with On File Change mode, as On File Change overrides it. This option allows GoodSync to Analyze and Sync this job when GoodSync starts up. NOTE: This setting should not be used together with On File Change mode, as On File Change overrides it. Network Connect or Disconnect: FTP, SFTP, DAV folders may connect or disconnect.Insertion or Ejection of Portable Volume: detachable folders may connect or disconnect.The following events speed up detection of connected/disconnected status: This option allows GoodSync to Analyze and Sync this job when specified location is made available.īy design, GoodSync checks every 3 minutes for the status of the left and right folders to determine availability. NOTE: If changes occur during Analyze/Sync, they are still detected and sent to the next Analyze interval. The On File Change Delay timer determines how many seconds since the last detected change before GoodSync will start the Analyze and Sync processes. Any of the above file systems remotely accessed via the GSTP protocol using GS Connect. Windows shares (except some faulty NAS shares that do not report changes).Windows File System and local disks (except root folder).On File Change supports the following file systems: This option allows for monitoring of the source and/or destination for changes and replicates them in real-time. This is an overview of the "Auto" section in Job Options.
0 Comments
Read More
Leave a Reply. |